Showing all 8 results
N and U-type connection sleeves must be held by collar clamps.
These collar clamps are specifics (30 mm high) and require several fixing points depending on their diameter.
The clamping rings are submitted to vibrations, then wear and tiredness. They must be replaced at the same time as the joint they hold.
We have several types of connection sleeves: N-type, Sigma, U-type, and URA,
each with a different profile. These profiles are made of different materials according to the environment of the tank activator (ATEX, food, chemical environment, temperatures).
Considering the wear of the components of the connection sleeves, we recommend their preventive replacement every 5 years.
It is possible to adapt these couplings to non ISERCO skip activators.
The most sensitive part of the seal is the upper part of the bin activator (connection sleeve) due to its diameter. In fact, the larger the diameter, the greater the possibility of leakage. The outlet of the bin activator is subjected to the same stresses as the inlet. When it is time to replace the inlet sleeve, the outlet sleeve must also be replaced.
It’s possible to use a U-shaped sleeve called Iserkit instead of a flat sleeve.
ISERCO devices (bin activators, big bag emptying/filling stations) integrate more automated processes. For safety reasons, presence sensors are used to indicate to the PLC whether all the conditions for starting an operation have been met. Product detection sensors, which indicate the level of filling of a bag (start/end), are commonly used to avoid jams.
Their replacement depends on their use. We recommend regular checks on these sensors, especially on the condition of their connectors.
We recommend that the user has a model of detector available on site for each type used in the installation.
There are on the market many kinds of shaft manufacturing (continuous welds, rolled spiral or constant thickness). The shaft spiral allows the movement of a powder in a closed chamber using friction. There is always wearing on spire tops. The wearing of the shafts spiral depends on their uses. Their replacement will be immediately realized as soon as a loss of flow capacity will be noticed. Shaft spirals are made upon demand according to their specific side. That’s why we suggest keeping spare parts available near the workplace.
The suspensions are one of the essential elements for the good functioning of the bin activators. Their main purpose is to absorb the filtration of vibrations and not to generate vibrations in the silo.
The suspensions are made of rubber which vulcanises and hardens over time. We have developed new suspensions that allow a better life and a better quality of absorption of the filtration of the vibrations. The suspension rod, which is subjected to stress, undergoes a specific heat treatment to increase its resistance.
We can adapt our suspensions to your non-Iserco bin activators.
We recommend a preventive replacement every 5 years.
This tubular sheath or trough “imprisons the shaft” so that the product can move inside.
The inside part of the sheath is also subject to frictions and then wear. The wear will depend on the conditions of use and do not require preventive replacement. However, we recommend that both the shaft and sheath are always kept in stock.
The centrifugal force and frequency of the unbalanced motor(s) are chosen considering the device to move. An inappropriate choice of vibrator can cause malfunctioning of the equipment and, in the worst case, self-destructive phenomena (cracks).
The life of these motors depends on their use, so preventive replacement is not justified. However, we recommend that you keep at least one spare motor on site for possible replacement, as defined by ISERCO for each type of motor.
